Fuji Xerox DocuPrint CM415 AP

Connectivity & Network Setup
171
Tools
5
 Port Number
Enter a port number from 1 to 65535.
The default value is 80.
Important • Do not use a number that is the same as a port number of another port. However, you can use the
same port number for a port that uses HTTP (IPP, Internet Services (HTTP), UPnP Discovery, SOAP,
WebDAV, and Web Services on Devices (WSD)).
Internet Services (HTTP)
 Port Status
Select [Enabled] to use CentreWare Internet Services.
For more information about CentreWare Internet Services, refer to "CentreWare Internet Services Settings" (P.279).
 Port Number
Enter a port number for the Internet Services from 1 to 65535.
The default value is 80.
Important • Do not use a number that is the same as a port number of another port. However, you can use the
same port number for a port that uses HTTP (IPP, Internet Services (HTTP), UPnP Discovery, SOAP,
WebDAV, and Web Services on Devices (WSD)).
Note • You cannot select [Port Number], if HTTP port is disabled.
To configure [Port Number], enable port status and reboot the machine, and then configure [Port
Number].
SOAP
 Port Status
Select [Enabled] when you use an application program such as Device Setup.
 Port Number
Enter a port number for SOAP from 1 to 65535.
The default value is 80.
Important • Do not use a number that is the same as a port number of another port. However, you can use the
same port number for a port that uses HTTP (IPP, Internet Services (HTTP), UPnP Discovery, SOAP,
WebDAV, and Web Services on Devices (WSD)).
WebDAV
 Port Status
Select [Enabled] when you use an application program such as Network Scanner Utility 3 to
access folders in the machine.
We recommend you to enable [HTTP - SSL / TLS Communication] under [SSL / TLS Settings]
when you use WebDAV. This is an effectual way to avoid password leaking.
Note • You cannot select [Port Number] and [Operation Time-Out], if WebDAV port is disabled.
To configure [Port Number] and [Operation Time-Out], enable port status and reboot the machine,
and then configure [Port Number] and [Operation Time-Out].
 Port Number
Enter a port number for WebDAV from 1 to 65535.
The default value is 80.
Important • Do not use a number that is the same as a port number of another port. However, you can use the
same port number for a port that uses HTTP (IPP, Internet Services (HTTP), UPnP Discovery, SOAP,
WebDAV, and Web Services on Devices (WSD)).