ESC/P-K Emulation
533
Appendix
15
The Pages per Side feature can be used in the ESC/P-K emulation mode. In the ESC/P-K
mode, 2 Up can be used.
Form Overlay
In the ESC/P-K mode, you can register an original form on the machine, and overprint the
form on a printout.
The form to be used for overlaying can be specified on the control panel.
For more information on registering forms, contact our Customer Support Center.
Barcodes
In the ESC/P-K mode, you can use barcodes. The barcodes that can be used are as follows:
z
EAN-13
z
EAN-8
z
Interleaved 2 of 5
z
UPC-A
z
UPC-E
z
CODE39
z
CODE128
z
POSTNET
Forms
You can use ESC/P-K to register forms on the machine. Up to 64 forms can be registered.
For more information on registering forms, contact our Customer Support Center.
ESC/P-K Emulation Settings
The following tables show the basic and extended settings that can be configured on the
ESC/P-K emulation mode menu.
Basic Settings
Setting Item
Item
Number
Value
Output color 5 Sets the output color.
[0] (Default) : Color
[1] : Monochrome
Paper tray 3 Sets the paper tray to be used for printing.
[0] : Auto
[1] (Default) : Tray 1
[2] : Tray 2
[5] : Tray 5
If printing from Tray 5, instruct printing and then operate the machine to
start printing. To cancel the setting, change the setting for "Tray 5
Confirmation".
Important • When Tray 1 or 2 is selected, the paper size is determined by the size of
paper loaded in the tray, and thus [Paper Size] cannot be set.
Note • When [Auto] is selected and paper of the same size in the trays is loaded,
paper will be fed in the order of Tray 1 J Tray 2.
To Next Page
Loading...
