Fuji Xerox DocuPrint CM415 AP Administrator's Guide

15 Appendix
552
Appendix
15
PCL Settings List
The following table describes the parameters that can be set with the mode menu.
Parameter Item No. Value
Paper tray 201 Sets the paper tray to be used for printing.
[0] (Default) : Auto
[1] : Tray 1
[2] : Tray 2
[5] : Tray 5
Important • When Tray 1 or 2 is selected, the paper size is determined by the size of paper
loaded in the tray, and thus [Paper Size] cannot be set.
Note • When [Auto] is selected and paper of the same size in the trays is loaded,
paper will be fed in the order of Tray 1 J Tray 2.
Auto size 202 Sets the default paper size. Only available when [Paper Tray] is set to [Auto].
Only cut sheet can be set.
[4] (Default) : A4
[5] : A5
[15] : B5
[21] : 8.5 × 14"
[22] : 8.5 × 13"
[23] (Default) : 8.5 × 11"
[25] : Custom Size
Important • When Tray 1 or 2 is selected, [Paper Size] cannot be set. The paper size loaded
in the specified tray is displayed.
Note • When Tray 1 or 2 is selected, the paper size is determined by the size of paper
loaded in the tray, and thus [Paper Size] cannot be set.
• Depending on the combination of [Original Size] and [Paper Size], [?] may be
displayed for the magnification. In this case, the document is printed at a
scale of 100%.
Bypass size 203 Sets the default paper size. Only available when [Paper Tray] is set to [Auto].
Only cut sheet can be set.
[4] (Default) : A4
[5] : A5
[15] : B5
[21] : 8.5 × 14"
[22] : 8.5 × 13"
[23] (Default) : 8.5 × 11"
[25] : Custom Size
Orientation 205 Set the orientation of paper.
[0] (Default) : Portrait
[1] : Landscape
2 Sided printing 206 Sets the 2 sided printing.
[0] (Default) : Off
[1] : On

Fuji Xerox DocuPrint CM415 AP Specifications

General

Brand	Fuji Xerox
Model	DocuPrint CM415 AP
Category	All in One Printer
Language	English