Connectivity & Network Setup
181
Tools
5
The default value is 88.
Important • Do not use the numbers assigned to the other ports.
îš„ Domain Name
When you use Active Directory of Windows 2000 Server, Windows Server
®
2003, Windows
Server 2008, or Windows Server 2012 as server, specify the domain name of Active Directory
in [Domain Name]. Up to 64 characters are allowed.
Important • Enter a realm name in uppercase characters. Otherwise, an authentication error occurs.
îš„ Server Certificate Verification
Select whether or not to verify a server certificate.
LDAP Server/Directory Service Settings
Configure the directory server, authentication method, and search attributes and ranges for
LDAP authentication and the Address Book search by LDAP.
îš„ Primary Server Name/Address
Enter the primary server name or IP address.
Note • For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value from 0 to
255.
• For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where "xxxx" is a
hexadecimal value.
îš„ Primary Server - Port Number
Set the Primary server port number from 1 to 65535.
The default value is 389.
Important • Do not use the numbers assigned to the other ports.
îš„ Secondary Server Name/Address
Enter the secondary server name or IP address.
Note • For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value 0 to 255.
• For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where "xxxx" is a
hexadecimal value.
îš„ Secondary Server - Port Number
Set the secondary server port number from 1 to 65535.
The default value is 389.
Important • Do not use the numbers assigned to the other ports.
îš„ Authentication Method
Select a method to perform LDAP authentication from [Direct Authentication] and
[Authentication of User Attributes].
z
Direct Authentication
User ID and password entered by a user are used for LDAP authentication.
z
Authentication of User Attributes
The user ID entered is used as an attribute specified in [Attribute of Typed User Name] to
perform a search on the LDAP server. [Attribute of Login User Name] of a user found
through the search is used as the user ID of a job and the owner of a job flow sheet and
a folder.
To Next Page
Loading...
Need help?
General
