Output Format
131
Copy
3
1 Specify the orientation of the document in
[Original Orientation] on the [Layout
Adjustment] screen.
2 Place the document slightly away from the top
left corner of the document glass, and close the
document glass.
Important • Always use the document glass when
copying. You cannot use the document
feeder with this feature.
• Specify the orientation of the original document correctly.
• If the edges of the image are missing, slightly move the card inward on the document glass so that
the whole image can be scanned.
• When the reduced size is specified to copy an ID card, the machine may copy the ID card in a
different orientation from the original orientation depending on the magnification ratio specified.
For information on the copy magnification ratio for ID Card Copy, refer to "5 Tools" > "Common
Service Settings" > "Copy Service Settings" > "Copy Control" > "ID Card Copy - Reduce/Enlarge" in the
Administrator Guide.
For information on how to specify the orientation of a document, refer to "Original Orientation (Specifying the Orientation
of Loaded Documents)" (P.112).
3 Select [ID Card Copy] on the [Output Format]
screen.
4 Select [On].
Off
Disables ID card copying.
On
Enables ID card copying.
To Next Page
Loading...
Need help?
General
