Using the Operator Panel 96
Light Sequences
The following table shows the light status.
12 Printer Status
Error Ready
— Ready
The toner is low.
See also:
• "Replacing the Toner Cartridge" on page 136
— Downloading
Warming up after power on
Receiving data, Waiting for data, Printing
Printing when the toner is low.
See also:
• "Replacing the Toner Cartridge" on page 136
Returning from Sleep mode
— In Power Saver mode
See also:
• "Power Saver Mode" on page 35
No paper is loaded.
Load paper, and then press the button on the operator panel.
See also:
• "Loading Print Media in the Multipurpose Feeder (MPF)"
on page 66
The wrong size of paper is loaded.
See also:
• "Loading Print Media in the Multipurpose Feeder (MPF)"
on page 66
Paper jam occurred.
See also:
• "Clearing Jams" on page 100
Waiting for manual duplex printing
*1
Canceling job
— The toner is empty.
See also:
• "Replacing the Toner Cartridge" on page 136
The rear cover is opened.
Close the rear cover.
All other engine error: fan error, fusing unit error etc.
Turn off the printer, and then on.
To Next Page
Loading...
