Add-on modules / Upgrading
A26361-D1818-Z120-1-7619, edition 1 17
Memory Installation Procedure
When you install the memory modules, make sure the module aligns properly with the memory slot.
The modules are keyed to ensure that it is inserted only one way. The method of installing memory
modules are detailed by the following diagrams.
Once the memory modules are firmly seated in the slot, two latches on either side will close and
secure the module into the slot. Sometimes you may need to close the latches yourself.
To remove the memory module, simply push the latches outwards until the memory module pops up.
Then remove the module.
!
YOU MUST ALWAYS unplug the power connector from the motherboard before
performing system hardware changes. Otherwise you may damage the board and/or
expansion device.
Attaching Drive Cables
Attaching the IDE drive cable is simple. These cables are “keyed” to only allow them to be connected
in the correct manner. The mainboard D1818 has two on-board IDE channels, each supporting two
drives. The black connector designates the Primary channel, while the white connector designates
the Secondary channel.
Simply plug in the BLUE END of the IDE cable into the motherboard IDE connector, and the other
end(s) into the drive(s). Each ATA-133 IDE cable has three connectors, two of which are closer
together. The BLUE connector that is furthest away from the other two is the end that connects to the
motherboard. The other two connectors are used to connect to drives.
To Next Page
Loading...
Need help?
General
