.com
Safety instructions
4
− Only insert CDs/DVDs in the drive when required and remove them after
use.
− Store the CDs/DVDs in appropriate cases. Protect them from heat and
direct sunlight.
Cleaning
• Clean your PC regularly. Before doing so, switch off the PC and any
peripherals, removing the plug from the socket.
• Use a non-abrasive cleaning product and/or a lightly dampened cloth.
• Avoid using cleaning sprays and any kind of solution containing alcohol or
other flammable liquids. Therefore do not use any abrasive powder or cleaning
agent which dissolves plastic for cleaning.
• Clean the monitor screen with a soft, lint-free dampened cloth.
Additional notes for proper operation
• Position the unit so that there is adequate air for cooling. Never cover the
ventilation slots on the unit. This could cause overheating and thus shorten the
life of your unit.
• With some devices, the manufacturer has applied films to sensitive surfaces to
protect against mechanical damage. These protective films should be removed
before startup.
• We recommend that you place the unit on a non-slip surface. The diversity of
coatings and varnishes used on furniture means that we cannot guarantee that
the rubber/plastic feet on the unit will not cause damage to the surface on
which it stands.
• Protect your device from very high humidity, direct sunlight as well as high and
extremely low temperatures. If the device is brought from a cold environment
into a warmer installation site, bedewing may occur. Wait until the temperature
of the device has equalised and it is completely dry before you put it into
operation (approx. 2 to 4 hours).
• The device is not watertight. Do not immerse the device in water and protect it
from spray (rain, sea water).
• Should an abnormal odour or smoke be produced and in emergencies (e.g.
damage to the housing, operating controls or power cable, and liquid or foreign
bodies entering the unit), switch the device off immediately, remove the plug
and contact your sales agent or our hotline/Help Desk.
• Do not smoke in the vicinity of the unit. Particles of ash may settle on the
monitor or inside your computer.
• Do not eat over the keyboard as crumbs may cause it to malfunction.
• Ensure that the cables from the computer do not pose any risk (danger of
stumbling) and cannot be damaged.
• The computer should preferably be transported in the original packaging as it
has been specially designed for the system unit.
• The ID plate may also be located underneath the housing.
• You may have to remove a securing device used during transportation from
the underside of the mouse.
• When you switch off ATX and µATX systems, the system will still be in standby
mode and still be connected to the mains. You will have to disconnect the
mains plug to isolate the unit.
bostext
To Next Page
Loading...
Need help?
General