Safety instructions
5
• If the monitor is connected to the power socket on the PC power supply unit (if
available), it will not be turned off when the PC is switched off.
• If you have a monitor which supports power management, it will also switch to
standby. If the monitor does not have this function, you must switch it off
separately when you finish working with the PC.
• The hard disk has already been formatted and the operating system has been
installed. It will only need to be formatted if the drive has to be reconfigured.
• The "Product Recovery CD/DVD" supplied can only be used to restore/install
your operating system if a motherboard with a Fujitsu Siemens Computers
BIOS is being used.
• Consumer PC systems are not suitable for high security and medical
applications.
Safety Information for Units with Liquid Cooling Systems
The cooling system is housed in a sealed safety cooling system which uses an
environmentally certified coolant. This liquid is non-toxic, non-combustible, non-
conductive and recyclable.
The liquid cooling system is monitored by the BIOS. Should a fault occur in this
liquid cooling system, the BIOS activates an error message when the system is
started.
• When cleaning the device, do not use any aggressive cleaning agents or
pointed or sharp objects which could cause damage to the connection cables
of the cooling system if allowed to penetrate the outer casing.
• In countries subject to very low or very high outside temperatures, please note
the transport temperature specified in the user manual under "Technical Data
and Operating Conditions" when transporting the unit outdoors.
Repair, modification and upgrading the computer
As this system was designed in such that its hardware and thermal technology
dovetail, enabling the manufacturer to guarantee faultless function, hardware
repairs and changes must only
be carried out by authorised persons.
The incorrect installation of components not certified by the manufacturer may
cause serious damage to the unit. Fujitsu Siemens Computers bears no liability for
any resulting consequential damage. If you have any questions, please contact the
manufacturer or the hotline.
Data backup
• Create backup copies of your work files on a regular basis. This is the only way
to protect against data loss, e.g. in the event of a hard disk fault.
• No liability shall be accepted for loss of data.
Special handling of batteries and rechargeable batteries
• The batteries/rechargeable batteries in our units do not contain any Cd or Hg
compounds.
• Your system is equipped with a replaceable lithium battery. It is located on the
system board. Once the battery is flat, it can be exchanged.
bostext
To Next Page
Loading...
Need help?
General