Remote switch setting
• Remote controller address setting (SW3)
This switch can be used when group control system. Set the remote controller address in the
1,2,-,15 order.
SW3 SW state Factory setting
0 Single ♦
1—15 Remote controller address
Jumper wire setting
• JM1 and JM2 setting prohibited
• Fan delay setting (JM3)
When the indoor unit is stopped while operating in conjunction with auxiliary heater, the indoor
unit fan operation will continue for one minute.
JM3 JM state Factory setting
Connect Disable ♦
Disconnect Enable
- 25 -
9-1. Models: ARXG45KHTA and ARXG54KHTA 9. Function settings
DUCT TYPE
ARXG45, 54KHTA
DUCT TYPE
ARXG45, 54KHTA
To Next Page
Loading...
Need help?
General
