SIZE (H x W x D mm) 139×56×18
WEIGHT ( g ) 85
ACCESSORY Holder
1
Signal Transmitter
2
OPERATION MODE button
3
SET TEMP. button ( / )
4
ECONOMY button
5
COIL DRY button
6
START/STOP button
7
TEST RUN button
This button is used when installing the air conditioner, and
z
should not be used under normal conditions, as it will cause the
indoor unit’s thermostat function to operate incorrectly.
If this button is pressed during normal operation, the indoor
z
unit will switch to test operation mode, and the Indoor Unit’s
OPERATION Indicator Lamp and TIMER Indicator Lamp will
begin to ash simultaneously.
To stop the test operation mode, press the START/STOP button
z
to stop the air conditioner.
8
SLEEP button
9
FAN CONTROL button
10
AIR FLOW DIRECTION SET button
11
SWING button
12
RESET button
13
TIMER OFF button
14
TIMER ON button
15
TIMER CANCEL button
16
Remote Controller Display
17
Transmit Indicator
18
Operation Mode Display
19
Timer Mode Display
OFF TIMER Mark:
ON TIMER Mark:
SLEEP TIMER Mark:
20
Fan Speed Display
21
Temperature and time Display
It displays the temperature setting.
However, when making the Timer setting,
it will display the Timer time.
(The temperature setting will reappear
after nishing the timer setting)
22
COIL DRY Display
23
SWING Display
To Next Page
Loading...
Need help?
General
