Fujitsu ASU30RLE - 13-2.Local Setting Procedure

- 80 -
OUTDOOR UNIT AOU30RLXEH
13-2. Local setting procedure
NOTE: Before performing the function setting, be sure to stop the operation of the air conditioner.
 Low noise mode
1. Press the MODE switch button (SW1) for 3 seconds or more to switch to “Local setting mode”.
2. After confirming the LED lamp of POWER/MODE blinks 9 times, press the ENTER switch
button (SW3).
3. Press the SELECT switch button (SW2), and adjust the LED lamp as shown below. Then the
LED lamp indicates the current setting.
4. Press the ENTER switch button (SW3).
5. Press the SELECT switch button (SW2), and adjust the LED lamps as shown below.
SW1
SW2
SW3 SW4 SW5
(1) (2) (3) (4) (5)
LED lamps
Switch buttons
POWER
MODE
ERROR
(L1) (L2) (L3) (L4) (L5) (L6)
PUMP
DOWN
LOW NOISE PEAK CUT
Blinks
(9 times )
Sign “ ”: Lights off
(L2)
(L3)
LOW NOISE
Blink
LOW NOISE
MODE
(L2) (L3)
LOW NOISE
LOW NOISE
MOD
E
Sign “ ”: Lights on
PEAK CUT
MODE 1
MODE 2
Blink
Blink
(L4) (L5) (L6)