To Next Page

To Previous Page

- 54 -

WALL MOUNTED

ASU30RLE

11-2. Custom code setting for wireless remote controller

To interconnect the air conditioner and the wireless remote controller, assignment of the custom

code for the wireless remote controller is required.

NOTE: Air conditioner cannot receive a signal if the air conditioner has not been set for the custom

code.

When 2 or more air conditioners are installed in a room, and the remote controller is operating an

air conditioner other than the one you wish to set, change the custom code of the remote controller

to operate only the air conditioner you wish to set. (4 selections possible.)

Confirm the setting of the remote controller custom code and the function setting. If these do not

match, the remote controller cannot be used to operate for the air conditioner.

NOTES:

• If no button is pressed within 30 seconds after the custom code is displayed, the system returns

to the original clock indicator. In this case, start again from step 1.

• The air conditioner custom code is set to prior to shipment. To change the custom code, contact

your retailer.

• If you do not know the assigned code for the air conditioner, try each of the custom code ( →

→ → ) until you find the code which operates the air conditioner.

1. Press the START/STOP button until only the clock is displayed on the

remote controller display.

2. Press the MODE button for at least 5 seconds to display the current custom

code. (Initially set to .)

3. Press the TEMP. ( ) ( ) buttons to change the custom code between

→ → → . Match the code on the display to the air conditioner custom

code. (Initially set to .)

4. Press the MODE button again to return to the clock display. The custom code

will be changed.

Fujitsu ASU30RLE Design & Technical Manual

Other manuals for Fujitsu ASU30RLE