Fujitsu ASYA09LEC User Manual

-
(
01 - 21
)
-
WALL MOUNTED TYPE AS

A09-12LE
WALL MOUNTED TYPE AS

A09-12LE
CONTENTS OF FUNCTION SETTING

Follow the instructions in the Local Setup Procedure, which is supplied with the remote control, in •
accordance with the installed condition.
After the power is turned on, perform the Function Setting on the remote control.
The settings may be selected between the following two: Function Number or Setting Value. •
Settings will not be changed if invalid numbers or setting values are selected. •
Wall
Mounted
1-1 Cooler room temperature correction ●
1-2 Heater room temperature correction ●
1-3 Auto Restart ●
1-4 Indoor Room Temperature Sensor ●
1-5 Remote controller Signal Code ●
1-1. Setting the Cooler Room Temperature Correction
Depending on the installed environment, the room temperature sensor may require a correction.
The settings may be selected as shown in the table below.
(

. . .Factory setting)
Setting Description Function Number Setting Value

Standard
30
00
Lower control 01
1-2. Setting the Heater Room Temperature Correction
Depending on the installed environment, the room temperature sensor may require a correction.
The settings may be changed as shown in the table below.
(

. . .Factory setting)
Setting Description Function Number Setting Value

Standard
31
00
Lower control 01
Slightly warmer control 02
Warmer control 03

Fujitsu ASYA09LEC Specifications

General

Brand	Fujitsu
Model	ASYA09LEC
Category	Air Conditioner
Language	English