Fujitsu ASYA09LEC User Manual

-
(
01 - 22
)
-
WALL MOUNTED TYPE AS

A09-12LE
WALL MOUNTED TYPE AS

A09-12LE
The following settings are also possible, depending on the operating conditions.
1-3. Auto Restart
(

. . .Factory setting)
Setting Description Function Number Setting Value

Yes
40
00
No 01
1-4. Indoor Room Temperature Sensor Switching Function
(Only for Wired remote controller)
The following settings are needed when use the control by Wired remote controller temperature
sensor.
(

. . .Factory setting)
Setting Description Function Number Setting Value

No
42
00
Yes 01
If setting value is “00”,
•
room temperature is controlled by the indoor unit temperature sensor.
If setting value is “01”,
•
room temperature is controlled by either indoor unit temperature sensor or remote controller unit sensor.
1-5. Setting the Remote controller Signal Code
Change the indoor unit Signal Code, depending on the remote controllers.
(

. . .Factory setting)
Setting Description Function Number Setting Value

A
44
00
B01
C02
D03
REMOTE CONTROLLER SIGNAL CODE SETTING

Use the following steps to select the signal code of the remote controller.
(Note that the air conditioner cannot receive a signal code if the air conditioner has
not been set for the signal code.)
Press the START/STOP button until only the clock is displayed on the remote 1.
controller display.
Press the MODE button for at least five seconds to display the current signal code 2.
(initially set to
).
Press the SET TEMP. (3.
) ( ) button to change the signal code between →
→
→ .
Match the code on the display to the air conditioner signal code.
Press the MODE button again to return to the clock display. The signal code will 4.
be changed.
If no buttons are pressed within 30 seconds after the signal code is displayed, the system returns to the original
clock display. In this case, start again from step 1.
The air conditioner signal code is set to A prior to shipment.
Contact your retailer to change the signal code.
The remote controller resets to signal code A when the batteries in the remote controller are replaced. If you use
a signal code other than signal code A, reset the signal code after replacing the batteries. If you do not know the
air conditioner signal code setting, try each of the signal codes (
→ → → ) until you find the code which
operates the air conditioner.

Fujitsu ASYA09LEC Specifications

General

Brand	Fujitsu
Model	ASYA09LEC
Category	Air Conditioner
Language	English