7. Proceed to number setting by pressing the FAN button.
To return to the function number selection, press the FAN button again.
8. Select the setting number by pressing the or the button.
Each time the MODE button is pressed, it switches between the left digit and the right digit.
9. Send the function mode information by pressing the TIMER MODE button once.
10. Send the function setting information by pressing the START/STOP button once.
2 short beeps will be emitted from the indoor unit when the signal is received correctly. If wrong
code is set, no beep sound will be emitted.
NOTE:
Press START/STOP button within 30 seconds after pressing TIMER MODE button.
Function details: Refer to Chapter 8-6. "Function details" on page 284.
- 265 -
8-2. Indoor unit (setting by wireless remote controller) 8. Function settings
SYSTEM
DESIGN
SYSTEM
DESIGN
To Next Page
Loading...
Need help?
General
