Fujitsu CELVIN NAS QE707 - System status checks

Installing the NAS
System status checks
The NAS is fitted with LED indic a tors to show the sys tem s tatus and further information. W hen you
switch on the NAS, check the following items to make sure that the system i s working normally.
Please note that the information provided by the LEDs described below is only valid if the hard disks
have been correctly installed and the NAS is connected to the netw ork and the power supply.
The image below shows the CELVIN® NAS QE807.
STATUS
LAN
USB
HDD1
HDD2
HDD3
HDD4
1
2
3
4
1 = System status
2=LAN
3=USB
4 = HDD 1 - 2 (QE707)
HDD 1 - 4 (QE807)
Fujitsu 15