Copying data using the front US B port
Copying data using the front US
Bport
Data can be copied directly from an external drive to th e NAS or vice versa by pressing the
one-touch copy button on the front of the device. To use this function, follow the steps below:
► Make sure a hard disk has been installed and formatted in the NAS. This
will create the USB standard network share.
► Switch on the NAS.
► Configure the function of the one-touch copy button on the page B a ckup
Manager - USB One-Touch Copy.
► Connect the USB drive (e.g. digital camera or flash drive) to the front USB port on the NAS.
► Press the one-touch copy b utton. Data will be copied to the NAS according
to the previously defined settings.
QE707
1 = One-touch copy button 2 = USB 3.0
Fujitsu 53
To Next Page
Loading...
