Fujitsu CELVIN NAS QE807 - Alarm buzzer

Installing the NAS
LED Colour LED status Description
Flashes blue
every 0.5 sec.
• A USB device has been identi fied a
tthe
front USB port.
• A USB device has been removed from the
front USB port of the NAS.
• Access to the USB device at the
front USB
port of the NAS.
• Data is being copied from or to the external
USB device
Blue
A USB device has been identified on the front
(after connection of the device).
USB
Blue
Off
• No USB device found.
•TheNAShasfinished copying the data from
or two the USB device at the f ront USB port.
Alarm buzzer
The alarm buzzer can be deactivated under Control Panel - Hardware.
The beep tha t sounds when the device is started up cannot be deactivated.
Signal tone No. of repetitions Description
Short beep (0.5 sec)
1
• The NAS is booting up.
• The NAS is shutting down (software shut
down).
• The user pressed the reboot button t o reboot
the NAS.
• The system firmware was updated.
Short beep
(0.5 sec) 3
An attempt i
s being made to cop y NAS data
to an exter
nal storage device connected to the
front USB p
ort, but the data cannot be copied .
Short be ep (0.5 sec),
Long beep (1.5 sec)
3, every 5 mins.
The system fan is not w orking.
2
• The hard disk is almost full.
• The hard disk is full.
• All the hard disks in the NAS are in degraded
mode.
• The user starts the hard disk recovery
process.
Long beep (1.5 sec)
1
• The NAS is in forced shut down (hardware
shut down).
•The
NAS started successfully and is ready
for
use.
Fujitsu 17