Fujitsu D3313-S - Step 3 Insert RAM; Step 4 Put Board in Chassis

Assembly Instructions D3313-S
__________________________________________________________________________________________________________________________________________________________
Page 5 of 15 www.fujitsu.com
Step 3 Insert RAM
If you only have one RAM attach it to the top slot, if you have two, start with the bottom slot.
Put in the first RAM tilted slightly upwards. Then push it down.
Now put in the second RAM in the same manner, putting it in tilted upwards and then pushing it down.
Step 4 Put Board in Chassis
Start by putting all the connectors on the board through the designated holes in the chassis.