System expansions
Fujitsu Technology Solutions 41
Replacing rear panel
► Open the casing (see "Opening the casing").
► Remove the cross-piece (see "
Removing the cross-piece").
► If necessary, remove the board bracket (see "
Removing board bracket").
1
2
3
a
► Disconnect the power supply connector (1) from the mainboard and the drives.
► Tilt the power supply forward in the direction of the arrow (2) so that the lug (a) unhooks.
► Carefully lift the power supply out of the casing in the direction of the arrow (3) and lay it next to
the device.
1
1
2
1
1
2
A
B
A = Rear panel for low-profile boards B = Rear panel for long boards
► Remove the four screws (1).
► Pull the rear panel from the casing in the direction of the arrow (2).
To Next Page
Loading...
