Fujitsu ESPRIMO E5635 - Installing Smartcard Reader And;Or WLAN Module

System expansions
Fujitsu Technology Solutions 71
Installing SmartCard reader and/or WLAN module
► Open the casing (see "Opening the casing").
► Remove the cover from the upper casing top cover if necessary (see "
Removing plastic drive
cover").
► Remove the cross-piece (see "
Removing the cross-piece").
1
1
► Slide the carrier into the casing in the direction of the arrow.
► Fold up the drive cage (see "
Folding up the drive cage").
► Fasten the holder with the screws (1).
► Fold down the drive cage (see "
Folding down the drive cage").
► Connect the cables.
► Replace the cross piece (see "
Installing the cross-piece").
► Close the casing (see "
Closing the casing").