System expansions
52 Fujitsu Technology Solutions
Removing an optional port
► Open the casing (see "Opening the casing").
► Disconnect the cable from the connector on the mainboard.
2
1
3
5
4
► Press on the locking lever in the direction of the arrow (1), unhook it and swing it up in the
direction of the arrow (2).
► Remove the port from the slot (3).
!
For cooling, protection against fire, and in order to comply with EMC (electromagnetic
compatibility) regulations, you must refit the cover plate.
► Push the rear slot cover plate into the slot (4). Ensure that the point of the cover engages on
the outside of the casing.
► Fold the lock closed in the direction of the arrow (5) and allow it to engage.
► Close the casing (see "
Closing the casing").
To Next Page
Loading...
