|Hot-adding disk shelves with IOM12 modules|
------------ --------- --------------------------
----------------------- ----------- ------
stor-8080-1 1a - -
- -
stor-8080-1 0d - -
- -
stor-8080-2 1a - -
- -
stor-8080-2 0d - -
- -
Errors:
------
-
7. If you disabled disk ownership automatic assignment in Step 1, manually assign disk ownership, and then
reenable disk ownership automatic assignment if needed:
a) Display all unowned disks:storage disk show -container-type unassigned
b) Assign each disk:storage disk assign -disk disk_name -owner owner_name
You can use the wildcard character to assign more than one disk at once.
c) Reenable disk ownership automatic assignment if needed:storage disk option modify -
node node_name -autoassign on
You need to reenable disk ownership automatic assignment on both controllers in an HA pair.
8. If your configuration is running in-band ACP, verify that in-band ACP was automatically enabled on hot-
added disk shelves: storage shelf acp show
In the output, “in-band” is listed as “active” for each node.
17
To Next Page
Loading...
