Chapter 7 System Environment Settings
7.1 Required Settings for the Key Management Function
FUJITSU Storage ETERNUS DX Configuration Guide (Web GUI)
Copyright 2014 FUJITSU LIMITED P2X0-1250-06ENZ0
110
7.1.1.3 Key Group Settings for the RAID Group
(1)Set key group
Register any RAID groups that use the same key from the key server in the key group.
Refer to "Set Key Group (RAID Group)" in "ETERNUS Web GUI User's Guide (Settings)".
(2)SED key group
Check the key group setting status of the RAID group.
Refer to "SED Key Group" in "ETERNUS Web GUI User's Guide (Operation)".
■ Relation between the ETERNUS DX S3 series and the key server
The following figure shows the relation between the ETERNUS DX S3 series and the key server.
Figure 7.1 Relation between the ETERNUS DX S3 series and the key server
The ETERNUS DX S3 series obtains the key from the key server by using the "Storage System Group Name",
"Key Management Machine Name", and "Key Group Name" as the password.
Key Server
Device Group Name
(Default name: ETERNUS_DX)
Storage System Group Name
Storage system A
Machine ID
Key Management Machine Name #1
Storage system B
Machine ID
Key Management Machine Name #2
Key Group Name
Serial No. for storage system A
Key Group Name
Serial No. for storage system B
To Next Page
Loading...
