Chapter 3 Initial Setup
3.1 Initial Setup 1
FUJITSU Storage ETERNUS DX Configuration Guide (Web GUI)
Copyright 2014 FUJITSU LIMITED P2X0-1250-06ENZ0
26
3.1 Initial Setup 1
The flow of wizard operations in Initial Setup 1 is shown below.
For details about each parameter setting, refer to "Appendix Parameter List" in "ETERNUS Web GUI User’s
Guide (Settings)".
(1)Set Storage Name
Register the name, administrator, and installation site of the ETERNUS DX.
(2)Change Password
Change the password for the default account that is currently logged in before starting to use the ETERNUS
DX.
(3)Set Thin Provisioning
If using the Thin Provisioning function, select "Enable" and set the maximum pool capacity.
(4)Register Advanced Copy License
If using the Advanced Copy function, register the license here.
(5)Register SED Authentication Key
Register the Self Encrypting Drive (SED) Authentication Key to enable encryption of the SEDs.
This function is not displayed for the ETERNUS DX200F.
(6)Setup Network Environment
Set the environment for the ETERNUS DX to communicate on the network such as IP address and subnet
mask.
Log out when the settings are complete. Log in again, and then proceed to "3.2 Initial Setup 2" (page 35)
.
If SED has been installed before registering the SED authentication key, reboot the ETERNUS DX before
logging in again.
To Next Page
Loading...
