Fujitsu ETERNUS DX100 S3 - Page 38

Chapter 3 Initial Setup
3.2 Initial Setup 2
FUJITSU Storage ETERNUS DX Configuration Guide (Web GUI)
Copyright 2014 FUJITSU LIMITED P2X0-1250-06ENZ0
38
4 Proceed to [Setup SNMP Agent Basic Interface].
4-1 Specify the parameters.
The main setting items are as follows.
- SNMP Function
- LAN Port used for SNMP
- Authentication Failure
- Engine ID
- MIB-II RFC Version
4-2 Click the [Next >>] button.
 A confirmation screen appears.
4-3 Click the [OK] button.
 Setting of the SNMP Agent basic starts.
4-4 Click the [Done] button.
Click the [Skip] button to proceed to the next screen without setting.