Fujitsu ETERNUS DX100 S3 - Page 68

Chapter 5 Host Interface Management
FUJITSU Storage ETERNUS DX Configuration Guide (Web GUI)
Copyright 2014 FUJITSU LIMITED P2X0-1250-06ENZ0
68
Set Host Response
Set the appropriate operation mode on which the host makes connection.
Refer to:
-
Set Host Response
Add Host Group
Add the information of any server that accesses the ETERNUS DX via the host interface ports.
When adding a server, create a host group (a host (HBA) group that accesses the same LUN
group). Assign a host response when creating a host group.
When adding new host groups, refer to:
-
Add Host Groups
The concept of host connection settings is described in "Appendix B Structures for Host
Connection" (page 123).
Create Host Affinity
To recognize the LUN group from the server, allocate the host groups with the CA port groups
and the LUN groups.
Refer to:
-
Create Host Affinity
Set CA Reset Group
Set member ports for a CA reset group to reduce the effect when ports become inaccessible.
Refer to:
-
Modify CA Reset Group