See
Refer to the
ETERNUS SF Web Console Guide
for the version level of the supported web browsers and methods for launching and
logging into the Web Console.
3.3 Registering Disk Storage Systems
In order to manage disk storage systems, first of all it is necessary to register disk storage systems to be managed.
Disk storage systems can be registered by using the Web Console.
Refer to "Register ETERNUS Disk Storage System" in the
ETERNUS SF Web Console Guide
for details on the operation procedures.
3.4 Registering Servers
In order to assign volume to a server using Express, it is necessary to register the target server in advance.
Using the Web Console, register a server to be managed by Express.
Refer to "Register Server" in the
ETERNUS SF Web Console Guide
for details on the operation procedures.
Then, add HBA to the registered server.
Refer to "Add HBA" in the
ETERNUS SF Web Console Guide
for details on the operation procedures.
Point
Registration of a server and the addition of HBA can be performed using the Storage configuration wizard. Refer to "3.6 Environment
Configuration Using Wizard" for details about the Storage configuration wizard.
3.5 Event Notification Test
Express performs the fault monitoring by processing events that are asynchronously reported by SNMP Trap from ETERNUS Disk storage
system. Therefore, check that the SNMP Trap settings are correctly done.
By sending E-mail to the destination address configured in advance when an abnormality occurs in the device, it is possible to notify
its abnormality to the system administrator and business administrator immediately.
This section describes the procedure for SNMP Trap reception test and E-mail send test.
3.5.1 Procedure for SNMP Trap Reception Test
Check that the Management Server can receive SNMP Trap.
Perform the following procedure to execute a SNMP Trap reception test.
1. Launch the ETERNUS Web GUI.
2. On the ETERNUS Web GUI, check that SNMP Trap destination from ETERNUS Disk storage systems is an IP address of the
Management Server.
SNMP Trap destination is automatically specified when ETERNUS Disk storage system is registered. Also, it can be manually
specified on the ETERNUS Web GUI.
3. On the ETERNUS Web GUI, send the SNMP Trap.
Refer to the ETERNUS Web GUI manuals for more information.
4. On the Web Console, check that the message has been displayed in the event log.
SNMP Trap Test has been completed successfully if the message including the character string of "SNMP Trap Test" is displayed
in the body of the message.
- 10 -
To Next Page
Loading...
