4.3.2 Collecting Troubleshooting Information
There are other methods to analyze the effects of the trouble besides "4.3.1 Identifying Trouble Condition". Use those methods as
required.
In addition, for hardware troubles, contact the hardware administrator when needed.
- Trouble information collection
The trouble information can be collect using either the esfsnap command or Web Console.
Refer to "Collecting Troubleshooting Information" in the
ETERNUS SF Web Console Guide
for using the Web Console.
- Displaying operation history
The Web Console operation (contents, execution status and results) history can be displayed.
Refer to "Display Operation History" in the
ETERNUS SF Web Console Guide
for details.
- Displaying login/logout history
The Web Console user login and logout history can be displayed.
Refer to "Display Login/Logout History" in the
ETERNUS SF Web Console Guide
for details.
4.3.3 Trouble Response
After identifying the trouble condition as shown in "4.3.1 Identifying Trouble Condition" or "Collecting the Troubleshooting
Information", contact a system administrator or a hardware administrator, referring to the message and trouble information.
After resolving the trouble, reload the configuration information to update information. Refer to "Reload ETERNUS Disk Storage System
Configuration Information" in the
ETERNUS SF Web Console Guide
for details on the operation procedures.
4.4 Executing Advanced Copy
This section describes the procedures for executing Advanced Copy.
Express can execute snapshot copy (SnapOPC+). The maximum number of copy sessions that can be executed with the device is as
follows:
Device Name Maximum Number of Copy Sessions
ETERNUS DX60/DX60 S2/DX80/DX80 S2/DX90/DX90 S2 8
ETERNUS DX100 S3 1024
ETERNUS DX200 S3
ETERNUS DX200F
2048
4.4.1 Connection Type Settings
Set up the type of the connection with ETERNUS Disk storage system used by Copy command via SAN or Copy command via LAN.
See
Refer to "System Configuration" in the
ETERNUS SF AdvancedCopy Manager Operation Guide for Copy Control Module
for details about
Copy command via SAN and Copy command via LAN.
There are two connection types.
Connection Type Explanation
Access through volumes If this type is selected the copy command is issued through the SAN interface.
Access through network If this type of selected the copy command is issued though the LAN interface.
- 25 -
To Next Page
Loading...
