Fujitsu Eternus DX600 S3 - Function Specifications; Operating Environment; Supported Oss (in SAN Environments); Table 3 Function Specifications (ETERNUS DX500 S3;DX600 S3)

Function Specifications
This section contains the specifications of the functions for the
ETERNUS DX.
Table 3 Function Specifications (ETERNUS DX500 S3/DX600 S3)
Item ETERNUS DX500 S3 ETERNUS DX600 S3
Supported RAID levels 0 (*1), 1, 1+0, 5, 5+0, 6, 6-FR (*2)
RAID groups Number of RAID groups (max.) (*3) 264 528
Number of volumes per RAID group (max.) 128
Thin Provisioning Pool (TPP)/
Flexible Tier Sub Pool (FTSP)
Number of pools (max.) (*4) 256
Number of volumes per pool (max.) (*5) 16,383
Volumes Number of volumes (max.) 16,384
Volume capacity (max.) 128TB
File system (NAS) File system capacity per ETERNUS DX (max.) 512TB 1,024TB
Number of connectable SAN
hosts (HBAs) (max.)
per storage system 1,024 (*6)
4,096 (*7)
per port 256
*1: Use of RAID0 is not recommended because it is not redundant. For RAID0 configurations, data may be lost
due to the failure of a single drive.
*2: Fujitsu original RAID level that provides the high speed rebuild function, and striping with double distrib-
uted parity.
*3: The maximum number of RAID groups that can be registered (for the RAID1 configuration).
*4: The maximum total number of TPPs and FTSPs.
*5: The maximum number of volumes that can be created in a TPP or an FTSP is calculated by subtracting the
number of RAID groups that configure the relevant TPP or FTSP from the maximum number of volumes that
can be created in the ETERNUS DX.
*6: The values if the controller firmware version is earlier than V10L60 or if the "Expand Host Mode" is disa-
bled.
*7: The values if the controller firmware version is V10L60 or later and if the "Expand Host Mode" is enabled.
Operating Environment
This section explains the operating environment that is required for ETERNUS DX operation.
Supported OSs (in SAN Environments)
Servers and OSs that are supported by the ETERNUS DX as a SAN host are shown below.
For details on servers, Host Bus Adapters (HBAs), and driver software combined, refer to "Configuration Guide -
Server Connection-".
2. Specifications
Function Specifications
20
FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Hybrid Storage Systems
Overview
Copyright 2019 FUJITSU LIMITED
P3AM-7702-29ENZ0