Event Notification
When an error occurs in the
ETERNUS DX, the event notification function notifies the event information to the
administrator. The administrator can be informed that an error occurred without monitoring the screen all the
time.
The methods to notify an event are e-mail, SNMP Trap, Syslog, remote support, and host sense.
The notification methods and levels can be set as required.
•
E-mail
When an event occurs, an e-mail is sent to the specified e-mail address.
•
SNMP Trap
Using the SNMP agent function, management information is sent to the SNMP manager (monitoring server).
•
Syslog
By registering the Syslog destination server in the ETERNUS DX, various events that are detected by the ETER-
NUS DX are sent to the Syslog server as event logs.
•
Remote support
The errors that occur in the ETERNUS DX are notified to the remote support center. Additional information
(logs and system configuration information) for checking the error is also sent. This shortens the time to col-
lect information.
•
Host sense
The ETERNUS DX returns host senses (sense codes) to notify specific status to the server. Detailed information
such as error contents can be obtained from the sense code.
Using the ETERNUS Multipath Driver to monitor the storage system by host senses is recommended. Sense co-
des that cannot be detected in a single configuration can also be reported.
Figure 20 Event Notification
SNMP
manager
Mail
server
Syslog server
Remote
suppor
t
center
REMCS/AIS Connect
Host sense
Server (host)
SyslogSNMP TrapE-mail
ETERNUS DX
3. Basic Functions
Operation Management
45
FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Hybrid Storage Systems
Overview
Copyright 2019 FUJITSU LIMITED
P3AM-7702-29ENZ0
To Next Page
Loading...
