28
3.1 Turning the Scanner ON
3.1 Turning the Scanner ON
This section describes how to turn the scanner ON.
The following shows the procedure for turning the scanner ON.
1.
Press the power button on the operator panel.
The scanner is turned ON, and the green LED on the operator
panel lights.
Also, while the scanner is being initialized, the indication of
the Function No. display changes as follows:
“8”->"P" -> "0" -> "1"
The "1" status on the operator panel is ready status.
HINT
To turn the scanner OFF, hold the power button
down for two seconds.
Power button
To Next Page
Loading...
