30
3.2 Loading Documents on the ADF for Scanning
3.2 Loading Documents on the
ADF for Scanning
The following shows the procedure for loading documents on the
ADF paper chute.
1.
Align the edges of the document.
To do this, perform the following.
1)
Align the front and side edges of the document to be
loaded.
Documents can be scanned more correctly if both edges
are aligned.
2)
Check the number of sheets in the document.
The standard number of sheets that can be loaded on the
scanner is as follows:
•
Number of sheets of A4-size paper or smaller that makes
a document stack of 5mm or less
•
Maximum 50 sheet at A4, 20 lb, or 80g/m
2
To Next Page
Loading...
Need help?
General
