AP-3
Appendix 2 DAILY CARE
■ Cleaning Materials
*1) It may take long before the cleaner vaporizes if a large quantity is used. When cleaning the scanner parts, dampen a
cloth with modest quantities of the cleaner. In addition, wipe off the cleaner completely with a soft lint-free cloth to
leave no residue on the surface of the cleaned parts.
*2)
For details about cleaning materials, contact the FUJITSU scanner dealer where you purchased the scanner.
■ Parts to Clean
Do not use any aerosol sprays or alcohol based sprays to clean the scanner.
Dust blown up by strong air from the spray may enter the inside of the scanner. This may cause the scanner
to fail or malfunction.
Sparks, caused by static electricity, generated when blowing off dust and dirt from the outside of the scanner
may cause a fire.
Cleaning Materials Parts Number Remarks
Cleaner F1 PA03950-0352 (*1) 1 bottle
Moisten the cloth with this fluid and wipe
the scanner clean. (*2)
Cleaning Wipe PA03950-0419 1 pack (24 sheets)
Pre-moistened with Cleaner F1, Clean-
ing Wipes are used instead of moistened
cloths.(*2)
Lint-free dry cloth Any commercially available cloth
Part to clean Remarks
Document holding pad Clean the locations using a soft
cloth moistened with cleaner F1.
Document bed
To Next Page
Loading...
Need help?
General