Chapter 6 Replacing the Consumables
Appendix
Glossary
Introduction
Index
Contents
TOP
120
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Scanner
Overview
Replacing the
Consumables
9 Attach new pick rollers (× 2) on the shaft on at a time.
1 Hold the bushing of the shaft in one hand and the pick roller with
the retaining clip facing towards you in the other hand, and then put
the pick roller on the shaft in the direction of the arrow . If you
rotate the pick roller in the direction of the arrow , you can put it
on the shaft more easily.
2 Hold the bushing of the shaft in one hand and the other pick roller
with the retaining clip facing towards you in the other hand, and
then put the pick roller on the shaft in the direction of the arrow
. If you rotate the pick roller in the direction of the arrow ,
you can put it on the shaft more easily.
10 Install the shaft of the pick roller in the side away from
you.
1 Insert the left end of the shaft into the slot, and lower the other end
gradually.
2 Rotate the bushing on the shaft in the direction of the arrow.
ATTENTION
Confirm that the pick rollers are attached properly. Otherwise, it
may cause feeding errors such as paper jams.
Make sure to insert the pick roller until it locks in place.
Shaft
Pick Roller
Retaining Clip
1
2
Shaft
Pick Roller
Retaining Clip
1
2
To Next Page
Loading...
