Index
Contents
Chapter 2 How to Load Documents
Appendix
Glossary
Introduction
TOP
51
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
How to Load
Documents
Area Not to Be Perforated
An error may occur when there are punched holes in the area
shaded in light blue in the figure below.
Use the flatbed (fi-7700/fi-7700S) to scan such documents.
Fig. 1
How to Load Documents with a Tab or Non-
Rectangular Documents
When scanning documents with a tab or non-rectangular
documents, load them so that they are not caught while they
are being fed.
Good Example
Bad Example
ATTENTION
The above condition applies when the document is set to the center of
the pick roller width.
HINT
If there are any holes in the 35 mm-wide central column, you can move
the document to the left or right to avoid an error.
Center
Top
Reference point
Feed
direction
Front side
(Unit: mm)
Bottom
35
ATTENTION
If you load a document as shown in the bad example, the document
may get caught while it is being fed, be scanned skewed, or it may get
jammed and damaged.
Feed
direction
Example: Non-rectangular
document
Example: Tab
Feed
direction
Parts that are caught
Example: Non-rectangular
document
Example: Tab
To Next Page
Loading...
