EasyManua.ls Logo

Fujitsu FI-7700 - Opening;Closing the ADF; Consumables; How to Close the ADF; Replacing the How to Open the ADF

Fujitsu FI-7700
233 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Appendix
Chapter 1 Scanner Overview
Glossary
Introduction
Index
Contents
TOP
24
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
This section describes how to open and close the ADF.
How to Open the ADF
1 Remove all documents from the ADF paper chute
(feeder).
2 Lift up the ADF release tabs to open the ADF.
How to Close the ADF
1 Close the ADF.
Push the center of the ADF until it locks in place.
1.4 Opening/Closing the ADF
When the ADF is open, it might close
accidentally. Be careful not to get your
fingers caught.
ATTENTION
Check that the document cover is closed and then open the ADF. If
you open the ADF with the document cover open, an error may
occur.
ADF Release Tabs
Be careful not to get your fingers caught
when closing the ADF.
ATTENTION
Check that there is no foreign matter caught inside the ADF and
then close it.

Table of Contents

Other manuals for Fujitsu FI-7700

Related product manuals