Chapter 8 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
191
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Operational
Settings
Adjusting the Output Result for Overscan
[Overscan Control]
The scanner can be configured to increase the amount of
black margin on the top and the bottom of the scanning area
so that part of the scanned image is not missing even when an
unusual skew occurs during overscan.
1 Start up the Software Operation Panel.
For details, refer to "8.1 Starting Up the Software Operation Panel"
(page 156).
2 From the listing on the left, select [Device Setting 2]
[Overscan Control].
3 Select the black margin amount.
Missing Added margin
Added
margin
When parts of the image
are missing
When [Expand] is selected
HINT
Specifying the maximum document size that can be scanned is
recommended.
This setting can also be configured with the operator panel.
To Next Page
Loading...
