Chapter 8 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
190
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Operational
Settings
Adjusting the Paper Picking Pressure [Pick
Pressure]
When scanning thin paper or when paper is not being fed
smoothly and the pick rollers repetitively rotate aimlessly until
paper is fed, adjusting the paper picking pressure improves
the performance of the scan.
1 Start up the Software Operation Panel.
For details, refer to "8.1 Starting Up the Software Operation Panel"
(page 156).
2 From the listing on the left, select [Device Setting 2]
[Pick Pressure].
3 Set the pick pressure for feeding paper.
Low: Select this option for thick or curled paper
Default: Default paper picking pressure. Keep this setting for normal
use.
High: Select this option for thin paper.
ATTENTION
Scanning thin paper with [High] selected may cause a paper
jam.
Scanning thick paper with [Low] selected may not feed the
paper properly, making the pick rollers repetitively rotate
aimlessly.
HINT
Selecting [High] strengthens the feeding force of the pick
rollers, feeding hard-to-feed documents quickly.
The [High] option is effective for scanning relatively thick
documents.
Selecting [Low] allows you to feed thin paper. However, if you
scan a document with a paper type that is not recommended,
make sure you test the same type of paper first to check if the
document can be scanned.
The [Low] option is effective for scanning relatively thin
documents.
This setting can also be configured with the operator panel.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
