ADF Paper Chute (Feeder)
Holds the documents to be scanned.
Chute Extension
Pull this out to adjust it to the document
length.
Side Guide
Positions the documents in place when
the documents are loaded in the ADF
paper chute (feeder) as they are fed into
the scanner.
Side Guide Button
Press and hold this to unlock the side
guide for adjusting the position.
The side guide is locked when the button
is released.
Operator Panel
Consists of an LCD, buttons, and LED
indicator. It can be used to operate the
scanner or check the status.
For details, refer to "Chapter 3 How to
Use the Operator Panel" (page 56).
Stacker
Stacks up documents that are
ejected from the ADF.
The height can be adjusted to either
a higher or lower position.
Stacker Extension
Pull this out to adjust it to the
document length.
Stoppers
Lift up either one according
to the document length.
Flatbed
When you scan a document that cannot be scanned
with the ADF, such as thin paper or a thick document
such as a book, place the document on the glass
section.
Transport Lock
Locks the carrier unit (which is inside the flatbed) to
prevent damage during transportation.
Use a coin or similar to unlock it.
Position the slot vertically to unlock it.
Position the slot horizontally to lock it.
ADF (Automatic Document Feeder)
Pulls and feeds the documents one sheet at a time from the ADF
paper chute (feeder).
For the fi-7700, it allows you to scan both sides of a document at the
same time.
Open this to replace consumables or to clean the inside of the
scanner.
Chute Roller Cover
Prevents your fingers from getting
caught in the chute roller.
Stacker Side Guide
Positions the documents in place when
the documents are stacked in the stacker.
Subtray
Allows you to temporarily place
documents to be scanned.
To Next Page
Loading...
