Index
Contents
Chapter 2 How to Load Documents
Appendix
Glossary
Introduction
TOP
49
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
How to Load
Documents
If there is dirt on the surface of the card, such as grease marks
(fingerprints), perform scanning after wiping the dirt off.
Plastic cards cannot be scanned when the imprinter is connected.
Scanning thick documents such as plastic cards will be falsely
detected as multifeed.
In that case, specify one of the following settings and try scanning
again.
- Use the Intelligent Multifeed function.
- Disable the multifeed detection setting.
- Use the Manual/Single mode.
To Next Page
Loading...
