How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Chapter 3 How to Use the Operator Panel
Appendix
Glossary
Introduction
Index
Contents
TOP
71
How to Load
Documents
Scanner
Overview
■Counting Documents
1 Press the [Power] button on the operator panel.
The [Ready] screen is displayed on the LCD.
2 Press the [Menu] button.
The [Settings Menu] screen is displayed on the LCD.
3 Press the [] or [] button and select [12: Doc Counting
Mode], then press the [Scan/Enter] button to confirm.
The [Doc Counting Mode (More documents)] screen is displayed on
the LCD.
4 Load a document in the ADF paper chute (feeder), and
press the [Scan/Enter] button.
The number of sheets that are scanned is counted.
The number of counted sheets is displayed in Count.
2 [Menu] Button
3 []/[] Button
[Scan/Enter] Button
4 [Scan/Enter] Button
1 [Power] Button
Me
n
u
Scan/Enter
C
h
e
ck
Powe
Stop/Clear
Me
n
u
Scan/Enter
Che
ck
Power
Stop/Clear
[fi-7600]
[fi-7700/fi-7700S]
ATTENTION
Documents may not be counted correctly if a multifeed occurs
during scanning.
HINT
To reset Count, press the [Stop/Clear] button while the [Doc
Counting Mode (More documents)] screen is displayed.
To end Doc Counting Mode, press the [Stop/Clear] button for
three seconds or longer while the [Doc Counting Mode (More
documents)] screen is displayed.
To Next Page
Loading...
