System expansions
3
2
2
1
4
► Place the SmartCard reade r on the carrier with the component side facing
downwards, in the direction of the arrow (1 ).
► Fasten the SmartCard reader onto the carrier with the screws (2).
► Connect the cable to the SmartCard reader (3) and to the connector on the mainboard (4).
► When required, reinstall the cross piece and the PCIe board (see "
Installing the board", Page 58).
► Close the casing (see "
Closing the ca sing", Page 62).
Make sure that the cables are not trapped between the casing and the components.
38 Fujitsu
To Next Page
Loading...
