System expansio ns
Installing and removing a Power
over Ethernet
module (optional)
You can install an additional P
ower over Ethernet module in your device.
Before using the module for th
e first time, please observe the notes
in chapter "
Getting started
", Page 16.
If you are supplying the s y
stem with power via the PoE module, ensure that
no additional power suppl
y (mains adapter) is co nnected.
Installing the Power over Ethernet module
PoweroverEthernetmo
dule,
► Open the casing (see "Opening the casing", Page 34).
► If a PCIe board is installed, you must rem ove the cross piece and PCIe
board (see "
Removing the board", Page 60).
► FUJITSU Desktop ESPRIMO A525-L: If a hard disk is installed, remove
it (see "
Removing a hard disk", Page 44).
1
2
► Break the cover (1) out of the casing.
► Place the Power over E thern et module in the casing with the component side
facing upwards (2). Ensure that it engages in the slot.
Fujitsu 55
To Next Page
Loading...
