Removing and installing com ponents
during servicing
Attaching the cover
2
2
1
2
2
2
2
2
2
► Place the cover in the correct mounting position (1).
Make sure that you have tightened the screws c orrect ly and that
the keyboard is firmly seated.
Make sure that you use the correct screws, they have different lengths.
► Tighten the screws (2).
► In ser t the battery (s ee Chapter "
Inserting battery", Page 33).
Finishing component removal
After you have removed or changed the system components a s you required, please
prepare your device for operation again as follows:
► Install the battery again ( see "
Inserting battery", Page 33).
► Turn the notebook the right way up again and place it on a flat surface.
► R eco nnect the cables th at you disconnecte d before.
56 Fujitsu
To Next Page
Loading...
