Fujitsu LIFEBOOK A544 - Error Message Resolutions

Troubleshooting and tips
Error messages on the screen
Errormess agesont he screenErrormessage:
This section describes the e rro r messages generated by the BIOS Setup. Error messages displayed
by the operating system or programmes are described in the relevant documentation.
If the error message appears repeatedly, despite troubleshooting measures, p lease
contact the place of purchase or our customer service centre.
Error message/cause Resolution
CMOS battery bad
If the e rror message occurs repeatedly, the
buffer battery in the notebook is flat.
► Contact your sales outlet
or our customer
service c entre.
System CMOS checksum bad - default configuration
used
The system configuration information is
incorrect.
► Switch the notebo ok of
f.
► Switch the notebo ok on.
► Press the function k
ey
F2
to access the
BIOS Setup.
► In the BIOS Setup, select the Exit menu.
► Select the entry Lo
ad Setup Defaults.
► Select OK and press the Enter key.
Extended memory failed at offset: xxxx Failing Bits:
zzzz zzzz
When testing the extende d m emory an error has
resulted at the address xxxx.
► Check whether the additional memory
module has been inserted correctly.
Failure Fixed Disk n
The settings of the hard disk drive a re incorrect.
► Start the BIOS Setup (Primary Master
submenu) and select the correct settings.
Keyboard controller error
► Switch the notebook off with the ON/OFF
switch.
► Wait 3 - 5 seconds and switch on the
notebook again.
Keyboard error
If you are using an extern al keyboard:
► Check the connection and reboot the
notebook.
nn Stuck key
► Make sure that no key is pressed.
Operating system not found
► Check
in the BIOS Setup whether your hard
disk h
as been set correctly.
► Make sure th at the operating system is
installed on the corresponding drive.
Press <F1> to resume, <F2> to SETUP
This error message appears if an error occurs
during the se lf-test before starting the operating
system.
► Press the
F1
function k ey to start the
operating system.
► Press the function key
F2
to access the
BIOS Setup.
64 Fujitsu