Removing and installing com ponents
during servicing
Attaching the cover
2
1
► Place the cover i
n the correct mounting position (1).
Ifyouremovemo
re than one component at th e same time, keep the screws for the
individual co
mponents separately from each other and make sure that you use the
correct screw
s. If you install the wrong screws, components may be damaged.
► Fasten the screw (2).
► Inser t the battery (see Chapter "
Inserting battery", Page 32).
Finishing component removal
After you have removed or cha nged t he system components as you required, please
prepare your device for operation again as follows:
► Install the battery again (see "
Inserting battery", Page 32).
► Turn the not ebook the right way up again and place it on a flat surface.
► Reco nnect the cables th at you disconnecte d before.
58 Fujitsu
To Next Page
Loading...
