Removing and in stalling components
during servicing
Removing and installing memory
expansion
MemorymoduleMainmemoryMemoryremovalSystemexpansionSystemexpansion
If you are asked by the Hotline/Service Desk to remove or install a memory
expansion module y ourself, proceed as follows:
Please observe the safety information in chapter "Important notes", Page 16.
During installation/removal of memory modules, the battery must remain
removed from the notebook and the notebook must not be connected to the
AC adapter, see "
Preparing to remove components", Page 66.
Only use memory modules th at have been approved for use in your
notebook (see cha pter "
Technical data", Page 84).
Never use force when installing or removing a memory module.
Make sure that no foreign objects fall into the memory upg rade compartment.
You must open the memory upgrade compartment to remove or install a memory
module. On some devices, it is possible th at opening the compartme nt exposes various
components. Only authorized specialists are permitted to remove or change these
components. Th erefore, be sure to observe the following:
Individual components can become very hot during operation. Therefore, we
recommend that you wait one hour after s witch ing the notebook off before removing
or installing memory modules. Otherwise, there is a risk of suffering burns!
As some components are exposed that are sensitive to static electricity, please take
note of chapter "
Notes on installing and removing boards and comp onents", Page 65.
Removing a memory module
3
2
1
1
► Carefully push th e two mounting
clips outwards (1).
Memoryexpa
nsion
Memorymodu
le
The memory module will fold upwards (2).
► Pull the memory module out of its s lot
in the direction of the arrow (3).
68 Fujitsu
To Next Page
Loading...
