Fujitsu LIFEBOOK E549 - Error Messages on the Screen

Troubleshooting and tips
Error messages on the screen
Errormessages onthescreenErrors
This section describes the error m essages generated by the BIOS Setup. Error m essag es displayed
by the operating system or programs are described in the d ocumentation for these programs.
If the error message appears repeatedly despite troubleshooting measures,
contact the place of purchase or our customer service c enter.
Error message/cause Troub lesho oting
CMOS Battery Bad
If the e rror message occurs repeatedly, the
back-up battery in the notebook is dead.
► Contact your sales outlet
or our customer
service center.
System CMOS checksum bad - Default configuration
used
The system configuration information is
incorrect.
► Switch the notebook of
f.
► Switch the notebook on.
► Press the function k
ey
F2
to access the
BIOS Setup.
► In the BIOS Setup, select the Exit menu.
► Select the entry Lo
ad Setup Defaults.
► Select OK and press the Enter key.
Extended memory failed at o ffset: xxxx Failing Bits:
zzzz zzzz
When testing the extended memory. an error
has resulted at the address xxxx.
► Check whether the additional memory
module has been inserted correctly.
Failure Fixed Disk n
The settings of the hard disk drive a re incorrect.
► Start the BIOS Setup (Pri m ary Master
submenu) and select the correct settings.
Keyboard controller error
► Switch off the notebook with the ON/OFF
button.
► Wait 3 - 5 seconds and switch on the
notebook again.
Keyboard error
If you use an external keyboard:
► Check the connect ion and re boot the
notebook.
nn Stuck key
► Make sure that no key is pressed.
Operating system not foun d
► Check
in the BIOS Setup whe ther your hard
disk h
as been set correctly.
► Make sure that the operating system is
installed on the corresponding drive.
Press <F1> to resume, <F2> to SETUP
This error message appears if an error occurs
during the self-test before starting the operat ing
system.
► Press the
F1
function key to s tart the
operating system.
► Press the function key
F2
to access the
BIOS Setup.
82 Fujitsu